Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
12367 Discussions

Programming emmc Flash using JTAG!

Altera_Forum
Honored Contributor I
1,016 Views

Hi Hi!! 

More and more "SoC Modules" are comming out just with one Boot/User flash chip on it!! These chips are usually eMMC 's!! 

And my question is? 

Is there a altera command or a tcl script to programm eMMC (over SD/MMC controller) using the JTAG interface??? 

Just like quartus_hps for QSPI Flash 's!!!!! 

If not!!!:cry: How complex it could be to programm a tcl script to control the SD/MMC controller and finally write "my Image" on my eMMC chip?? 

I am looking for, the easiest way (for production) to programm my flash (emmc) using JTAG! 

thanks for youre time! 

tschuss! 

c
0 Kudos
0 Replies
Reply