- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone.
I am new to Cyclone V soc and Qsys. I was trying to go through AN706 using Quartus II 14.0 (tried 15 & 16 also) on Windows 10 PC. However, I can not get Qsys to start. Here are a couple of thing I have found. 1. If I start Quartus and open a project "soc_system.qpf" and then start Qsys, it will start and go through initializing and then disappears. 2. If I start Quartus without opening a project and start Qsys, it will start. But, as soon as I try file->open, it closes. Since I am very new at this, I don't even know where to start. I looked online without much success resolving this issue. I've come across mentions of missing library but, did not find any instructions on how to install it. (If that is a solution to this issue) Any help on this would be very much appreciated. ThanksLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Duplicate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply Vikas. I will definitely try your link.
I am running free web version of Quartus II 14.0. Just wondering, is a paid license required to run Qsys? Also, I am trying to create Ethernet GPIO as a start point of my project. Are there any information available you could direct me to? I just purchased a DE10-Nano to get started. Thanks again and best regards,
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page