Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
12436 Discussions

SDcard to Cyclone II Schematics

Altera_Forum
Honored Contributor II
780 Views

Hi I want to interface SDcard or MicroSD to EP2C8Q208. 

1. Do I need to drive SD_CLK to PLL_Out pin or I can use any regular I/O on Cyclone 

2. I want to use SPI mode so only 4 signals are used, is this schematic correct and is there some other examples of connecting SDcard to Cyclone FPGA.  

3. I think also that adding 10K resistor on CLK signal is not best idea. 

Thanks
0 Kudos
0 Replies
Reply