- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am simulating my Nios II system in Modelsim. It's just a simple hello world project based on an351. I included one more sdram and hello world would be running out from sdram. I am driving my Nios II at 100 MHz, sdram at 100MHz and jtag uart at 50 MHz. I have a clock crossing bridge between them. But my expected output is not observed. Are both Nios II and jtag uart need to be driven by same freq? Thank you.
Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page