Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12482 Discussions

Simulating Nios II in MODELSIM

Altera_Forum
Honored Contributor II
815 Views

I am simulating my Nios II system in Modelsim. It's just a simple hello world project based on an351. I included one more sdram and hello world would be running out from sdram. I am driving my Nios II at 100 MHz, sdram at 100MHz and jtag uart at 50 MHz. I have a clock crossing bridge between them. But my expected output is not observed. Are both Nios II and jtag uart need to be driven by same freq? Thank you.

0 Kudos
0 Replies
Reply