These is something wrong about DDR reading and writing

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

These is something wrong about DDR reading and writing

909 Views

Hello everyone!

When I used the DDR sdram( MT46V16M16)as the palce in which the program run. The nios console showed that the verification was failed. So I changed to run the program in the onchip ram, and then writed and read the DDR. From the address of 0x2f6 to the address of 0x305, the data read was not the data written, the data between the address of 0x6f6 to 7f5, 0xaf6 to 0xb05, 0xef6 to 0xf05 were wrong, too. The data writen is its address, howere, the data read is 0.

When I change to run the program in another board, it have the same thing.

Thanks very much for your reply!!

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.