Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Altera_Forum
Honored Contributor I
753 Views

UART RS232 communications using HAL

How would I code a RS232 communications between NIOS and a computer?  

 

I would like to have a preable of the character '%' and end the message with '\r\n'  

 

How can i go about this?
0 Kudos
2 Replies
Altera_Forum
Honored Contributor I
41 Views

E.g. using printf() ?

Altera_Forum
Honored Contributor I
41 Views

yes. the printf is pretty striaghtfoward, I just cant figure out how to use the scanf to recieve communications?  

 

Should I do this polling round-robin, or interrupt based receive? Do i check the register to see if there is a message? Is there a software buffer for scanf?
Reply