Virtual UFM included in HW summary and bsp but pof file does not reflect increased space.

[MPETE26]

v18.1 tools,   Nios II/e  device: 10M16DCU324

uncomressed single image. Qsys configured for CFM2 as virtual-UFM (read-write) and memory map includes increased space. Code (.text) not carrying across into the new increased space. Map file from pof conversion still shows only UFM0+UFM1.

How do I get CFM2 to show up as part of the full UFM space?

[Ahmed_H_Intel1]

Hi,

Please check the following pages that will help you to understand the requirements and steps available:

 .pof and ICB Settings: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf#page=37

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf#page=7

Regards,

[MPETE26 · Accepted solution]

The issue has been identified. It was an incorrect device on the development HW: a 10M16DCU324 was installed while a 10M16DAU324 or 10M16DFU324 should have been installed.

The 'DC' does not support virtual-UFM in the CFM sectors. Doh!