Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
12453 Discussions

cant work ethernet on uClinux 2.6.x

Altera_Forum
Honored Contributor II
821 Views

Sorry, for my bad english. I have nios2 evaluation board with cyclone 1c12 with PHY ethernet module, and i use "nios2-linux-20090929". without "Ethernet (10 or 100Mbit) -> Opencores (Igor) Emac suppor" compilation is successful, but if i check it I has many error :  

 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c: In function `oeth_open': 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c:1575: error: `na_igor_mac_irq' undeclared (first use in this function) 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c:1575: error: (Each undeclared identifier is reported only once 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c:1575: error: for each function it appears in.) 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c: In function `oeth_close': 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c:1657: error: `na_igor_mac_irq' undeclared (first use in this function) 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c: In function `oeth_probe': 

/home/vlad/uClinux/distro/nios2-linux/linux-2.6/drivers/net/open_eth.c:2188: error: `na_igor_mac' undeclared (first use in this function) 

 

Thanks.
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
87 Views

maybe this problem with not correct configuration in SOPC builder?

Reply