Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12603 Discussions

hello from two tasks in microC/OS-II

Altera_Forum
Honored Contributor II
‎03-10-2014 08:28 AM
977 Views

Hi, I am new in microC/OS-II 

I am trying to run the hello MicroC/OS-II template from nios II SBT for eclipse in my own SOPC system. 

I am using Cyclone IV E ep4ce115F29c7 FPGA. 

My system has Nios II processor, 128KB memory on chip, sys_clk_timer=10ms,jtag-uart, sysid, clk=50 MHz. 

 

When I built the project: Builted completed (all looks fine) 

When I run the project: leaving target processor paused  

 

and nothing happens and I don't get the message os Hello task1... hello task 2... 

 

Help will be greatly appreciated
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.