Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12590 Discussions

implement interrupt by using custom component?

Altera_Forum
Honored Contributor II
955 Views

I want to implement interrupt by using custom component,fist I write a verilog HDL code;second ,i add it in Sopcbulider;at last,I write programme in IDE. 

but i found that the interrupt can't happen. 

whether you can give me some suggest or example code on iterrupt,Thank all 

 

verilog HDL code(this is very small code ) 

module test( 

clk, 

reset, 

write, 

writedata, 

irq 

); 

 

//inpnt signal 

input clk; 

input reset; 

input write; 

input [31:0]writedata; 

 

//output signal 

output irq; 

 

//Parameter 

parameter countval = 32'h0000_0010; 

 

reg [31:0]count; 

reg [31:0]ctl_reg; 

 

wire irq_enable; 

wire time_over; 

 

assign irq = irq_enable && time_over; 

 

always@(posedge clk or negedge reset) 

begin 

if(~reset) 

count = 0; 

else if(count >=countval) 

count = 0;  

else 

count = count +1; 

end 

 

always @(posedge clk or negedge reset) 

begin 

if (~reset) 

ctl_reg <= 0; 

else if (write) 

ctl_reg <= writedata; 

end 

 

assign irq_enable = ctl_reg; 

assign time_over = (count >=countval); 

 

endmodule 

___________________________________________________________ 

NIOS IDE C code# include <stdio.h># include <io.h># include "system.h"# include "sys/alt_irq.h" 

 

void test_interrupt(void* context, alt_u32 id)  

IOWR(TEST_0_BASE,0,0x0); // CLEAR INTERRUPT  

printf("Hello!\n"); 

IOWR(TEST_0_BASE,0,0x1); 

int main() 

int u;  

printf("Hello from Nios II!\n"); 

u=alt_irq_register(TEST_0_IRQ,0,test_interrupt); 

 

//alt_irq_enabled(); 

IOWR(TEST_0_BASE,0,0x1); // enable interrupt 

printf("Nios II!=%d\n",u); 

while(1); 

return 0; 

 

------------------------------------------------- 

I found it never interrupt ; what wrong with my work? I need help
0 Kudos
0 Replies
Reply