Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
12435 Discussions

opencore MAC 10/100M + qsys + uClinux

Honored Contributor II

i want to use the OPENCORE MAC in nios under uClinux. 

i connected like this in qsys: 

.igor_mac_global_mtxd_pad_o(ENET0_TX_DATA), // eth_ocm_0_global.mtxd_pad_o 

.igor_mac_global_mtxen_pad_o(ENET0_TX_EN), // .mtxen_pad_o 

.igor_mac_global_mtxerr_pad_o(ENET0_TX_ER), // .mtxerr_pad_o 

.igor_mac_global_mrx_clk_pad_i(enet0_rx_clk), // .mrx_clk_pad_i 

.igor_mac_global_mrxd_pad_i(ENET0_RX_DATA), // .mrxd_pad_i 

.igor_mac_global_mrxdv_pad_i(ENET0_RX_DV), // .mrxdv_pad_i 

.igor_mac_global_mrxerr_pad_i(ENET0_RX_ER), // .mrxerr_pad_i 

.igor_mac_global_mcoll_pad_i(ENET0_RX_COL), // .mcoll_pad_i 

.igor_mac_global_mcrs_pad_i(ENET0_RX_CRS), // .mcrs_pad_i 

.igor_mac_global_mdc_pad_o(ENET0_MDC), // .mdc_pad_o 

.igor_mac_global_md_pad_i(NET0_mdio_in), // .md_pad_i 

.igor_mac_global_md_pad_o(NET0_mdio_out), // .md_pad_o 

.igor_mac_global_md_padoe_o(NET0_mdio_oen), // .md_padoe_o 

.igor_mac_global_mtx_clk_pad_i(enet0_tx_clk) //  


connect the "tx_master " and " rx_master " to the SDRAM.s1 

am i right?
0 Kudos
0 Replies