Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

printf blocks

Altera_Forum
Honored Contributor II
896 Views

Hey, 

 

I guess printf blocks my program. When I connect the JTAG/blaster and open a terminal and let it print it runs again. 

 

I use the default device driver and not the reduced "small" driver and I have a system timer, also selected in the BSP editor. (Should it consist of specific parameters?) 

 

It would be awesome to solve it once and for all. I know a few threads discussed it already and there is this link from Altera: https://www.altera.com/support/support-resources/knowledge-base/solutions/rd12102004_5019.html but I couldn't solve it. 

 

Thanks, Eyar
0 Kudos
0 Replies
Reply