Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.

printf blocks

Altera_Forum
Honored Contributor II
858 Views

Hey, 

 

I guess printf blocks my program. When I connect the JTAG/blaster and open a terminal and let it print it runs again. 

 

I use the default device driver and not the reduced "small" driver and I have a system timer, also selected in the BSP editor. (Should it consist of specific parameters?) 

 

It would be awesome to solve it once and for all. I know a few threads discussed it already and there is this link from Altera: https://www.altera.com/support/support-resources/knowledge-base/solutions/rd12102004_5019.html but I couldn't solve it. 

 

Thanks, Eyar
0 Kudos
0 Replies
Reply