teraterm setting for sd card boot up. in cyclone 5

[Altera_Forum]

I 've just received my board, started to play with the SD card boot, the problem is when i use the teraterm with the setting mentioned, nothing printed out. but when i use the putty software and also same serial setting, it showed the log for the boot.. any one know what are the additional setting i nede to set in order to ues the teraterm connection?

[Altera_Forum]

this should be same setting too... what is the problem you see in teraterm actually?

[Altera_Forum]

nothing pop up from the black terminal screen, that's the problem.

[Altera_Forum]

did you change your option to tera term VT, in good sign? otherwise you will not see some printing from the terminal...in new lines

[Altera_Forum]

I will try this and let you know later. I feel using putty is easier.

[Altera_Forum]

both should be working the same if the setting is correct...