Hi All,
We have a custom Cyclone IV board with an SFP interfaced to the FPGA via SGMII on a standard Altera TSE. We also have an opencores i2c bus to control the moddef pins. We have a uClinux build that works with the same PCB but with a standard GMII/MDIO interfaces to a Micrel PHY. This works fine. Can anyone give me any assistance in what would be required to set up the drivers etc for SGMII rather than GMII? If it helps I am using the device tree for kernel config. Many thanks VernLink Copied
For more complete information about compiler optimizations, see our Optimization Notice.