Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12475 Discussions

unable to connect from jtag while devkit boots with bsel 0x7

Altera_Forum
Honored Contributor II
871 Views

My Altera's Devkit configured with BSEL 0x7 (boot from QSPI 3v), but nothing there. 

 

Fail to to load preloader from jtag with error message: 

ERROR(TAD9-NAL30): # in /home/abc/preloader.ds:12 while executing: stop 

! Unable to stop device Cortex-A9_0 

! Cannot stop target. 

ERROR(CMD656): The script /home/abc/preloader.ds failed to complete due to an error during execution of the script 

 

Is there a restriction to load from jtag when bsel is 0x7? 

If such, some help with workaround will be appreciated.
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
145 Views

er... can confirm all jumper setting in good form?

Altera_Forum
Honored Contributor II
145 Views

it was hardware problem with custom card. should close this one.

Reply