Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

use tse mac loopback

Altera_Forum
Honored Contributor II
818 Views

i want to use the loopback function of tse mac. 

how could i start it? 

thank you in advance! 

FangQJ
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
127 Views

Check the datasheet (http://www.altera.com/literature/ug/ug_ethernet.pdf): By just doing a search on the word "loopback", I found the relevant pages: 3-2 for hardware configuration, 4-18 and 4-19 for the procedure and 6-8 for the configuration register.

Altera_Forum
Honored Contributor II
127 Views

thanks Daixiwen, 

it's very helpful~ 

because i could not use two tse mac on DE2-115 board, which i stuck at the tse mac driver of nichestack, i want to use the loopback instead. 

thank you very much~ 

PS, any suggestion about using of two tse macs will be great~
Reply