Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.

use tse mac loopback

Altera_Forum
Honored Contributor II
814 Views

i want to use the loopback function of tse mac. 

how could i start it? 

thank you in advance! 

FangQJ
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
123 Views

Check the datasheet (http://www.altera.com/literature/ug/ug_ethernet.pdf): By just doing a search on the word "loopback", I found the relevant pages: 3-2 for hardware configuration, 4-18 and 4-19 for the procedure and 6-8 for the configuration register.

Altera_Forum
Honored Contributor II
123 Views

thanks Daixiwen, 

it's very helpful~ 

because i could not use two tse mac on DE2-115 board, which i stuck at the tse mac driver of nichestack, i want to use the loopback instead. 

thank you very much~ 

PS, any suggestion about using of two tse macs will be great~
Reply