Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Arria10 - Send linux command to the CPU through UART without minicom ?

Altera_Forum
Honored Contributor II
‎01-08-2017 06:49 AM
1,350 Views

Good morning, 

 

I am using an ARRIA10 Dev kit board which Linux is installed in the SD card and I can access it by using Minicom. 

 

In the embedded linux, I have a small program I could use with parameters. 

From the computer connected to the board, I would like to run a command and read the result. (in a C/JS/Ruby program) 

 

for example: from my Ruby program located in my desktop computer, I'd like to send the `cat afile.txt` command in the embedded Linux and see the value of the file. 

 

I didn't find any clue, is it possible ? (I guess so otherwise it's should be pretty useless) 

 

Thank you very much.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.