Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12595 Discussions

DDR problem, the mem_clk_n signal doesn't generate

Honored Contributor II

Hi everyone! 

I have a problem when I use ddr interface. The ddr chip is Micron MT 16M16BG-6:F, the fpga chip is ep3c120. When I build a sopc, and run the nios program in the ddr, the consle shows that: 


Verifying 02000000 ( 0%)  

Verify failed between address 0x2000000 and 0x200CDC7 

Leaving target processor paused 


The address of 0x20000000 is the start address of ddr sdram, so I think that there is some problem in the ddr interface. Therefore I use the singaltap to capture the signal of ddr interface, I find that the mem_clk_n singal doesn't generate, however the mem_clk has generated. The mem_clk_n and the mem_clk are assigned to a pair of DIFFIO pins.  


The signaltap wave is in the following picture. 


Thanks for your help!
0 Kudos
0 Replies