Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

Nios II flash programmer error

MGhad3
Beginner
1,990 Views

I get the error below during flash programming the elf file using the Nios II flash programmer. what is the reason?

 

Error code: 4 for command: nios2-flash-programmer "C:/CyclonV/C5_epcs_flash_controller_0.flash" --base=0x10000000 –epcs --accept-bad-sysid --device=1 --instance=0 '--cable=USB-Blaster on localhost [USB-0]' --program --verbose  

0 Kudos
3 Replies
Ahmed_H_Intel1
Employee
1,652 Views
Hi, The NIOS II flash programmer tool isn't recommended any more, can you please use one of the recommended procedures? The JTAG Indirect Confoguration procedure .jic file or Parallel flash programmer procedure I am sharing an example of using these two procedures to program the serial or parallel flash device:
0 Kudos
Ahmed_H_Intel1
Employee
1,652 Views

Here is the way to create a .JIC file to program your flash:

 

0 Kudos
Ahmed_H_Intel1
Employee
1,652 Views

Here is the procedure to use the PFL in programming a parallel flash device:

 

0 Kudos
Reply