- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I connected BAR2 to the ddr controller in the Altera's PCIe dma ddr reference design for Stratix V board. It compiled successfully. But when it download and after scan & found the pcie system, the lspci -x command, showing the same BAR address for BAR0 and BAR2!!. Why? Regards, FirozLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
sorry I do not have the answer for your problem yet, but seems that we are trying to run the same reference design and I'm having a problem too. I have compiled the s5 GX design ( http://www.alterawiki.com/wiki/reference_design_-_stratix_v_avmm_dma ) loaded it in the board, and rebooted the computer. I get the following errors: 1. lspci command does not return anything related to altera. 2. furthermore, when I try to ./install, in drivers and software fold, I get an error sayng that "altera_dma" has not been found in \proc\devices I guess error 2 is a consequense from error 1. So, could anyone help me? regards
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page