Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.

PIO problem

Altera_Forum
Honored Contributor II
1,459 Views

hai, 

I am using nios ii .I generated the components using Qsys and works fine.But when i add a single PIO to the existing Qsys whole thing gets collapsed. 

What can be the reason for this? 

I am not able to work with the code once i add this PIO?
0 Kudos
4 Replies
Altera_Forum
Honored Contributor II
703 Views

What error messages are you receiving?

0 Kudos
Altera_Forum
Honored Contributor II
703 Views

I am not getting any error message.The program hangs up after i hit the run.

0 Kudos
Altera_Forum
Honored Contributor II
703 Views

You can view this great video on Youtube. 

 

https://www.youtube.com/watch?v=hqde3xkwykk
0 Kudos
Altera_Forum
Honored Contributor II
703 Views

Did you re-generate BSP? and re-compile software codes (elf)? 

What does the PIO connected to? Did you enable interrupt for the PIO?
0 Kudos
Reply