Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12626 Discussions

Push Button ISR not called in the sample code

Altera_Forum
Honored Contributor II
1,535 Views

I am new to Cyclone V and VxWorks, I try to run the given sample code vxworks_sampleapp_ed_1.0. 

I followed the instructions in AN725_Sample_RTOS_Application.pdf and proceed till page 12 Running the Application. 

The LED 0 and 1 blinking is working, however when I try the push button FPGA0 and 1 the ISR is not called. 

I try to disable the ISR and do the polling on the alt_read_word(PUSH_BUTTON_DATA_ADDR); in a while loop. 

It returns 0x0 no matter the button is pressed or not. 

Same thing happen for the DIPSW. 

 

Anyone face this problem before?
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
405 Views

Hi i found the problem, the fpga image in my SD is not update to the ghrd_fpga. 

after replace the fpga image, it can run as stated. 

 

thank you.
0 Kudos
Altera_Forum
Honored Contributor II
405 Views

you are quite good, found your own missed out steps in about 1 hour!! bravo!

0 Kudos
Reply