- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm building a project in Quartus II for my board DE1_SoC. I created an IP and then connected it with HPS using Qsys via AXI4-lite interface, then, I launched Linux Yocto in HPS to program the FPGA. I used dd or cat to the port /dev/fpga0 when programming the FPGA with my project. Do I have to reset the FPGA part after programming using my method above? In similar platform from Xilinx, I am able to reset the FPGA by sending a value to Register Reset. Can I do that in Altera? For example by sending a certain value with /dev/mem in a program. Anybody with similar experience is welcome to give his/her opinion. Thanks a lot!Link Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page