Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12626 Discussions

Saving a project to on board flash memory to boot on start up

Altera_Forum
Honored Contributor II
1,010 Views

Hi guys, im very new to this but learning. 

 

Im have a project that works fine, but upon switching the board (DEO-Nano) off the program obviously disappears. I was told i can use the on board memory to save it there and upon powering up the board it will run. 

 

Can someone please explain how is it done, i can seem to find anything useful online :/ 

Thanks in advance.
0 Kudos
0 Replies
Reply