Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12686 Discussions

Writing data using IOWR

Altera_Forum
Honored Contributor II
‎03-12-2015 04:02 PM
1,613 Views

HI, 

 

I had created a custom component using qsys and using avalon MM interface. 

The base address was assigned as 0x5050. 

 

I'm using the command below for write and read operations. 

IOWR_32DIRECT(CUSTOM_COMPONENT_0_BASE, 0,4); 

INFO = IORD_32DIRECT(CUSTOM_COMPONENT_0_BASE, 0) 

 

It seems to me the write API was not functioning as the INFO is showing 1 instead 4. 

I'm currently using Quartus13. 

Is anyone know the reason/clues why the data is not being written correctly? 

 

Thanks  

HY
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-14-2015 12:46 AM
603 Views

http://www.alteraforum.com/forum/showthread.php?t=32282 

 

This link might be helpful. It points to a previous discussion.
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.