Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12678 Discussions

about flash2dat

Altera_Forum
Honored Contributor II
‎12-24-2004 08:27 AM
1,067 Views

Hello I'm suyo. 

 

I hava a question about flash2dat utility. 

flash2dat executes the following command. 

 

flash2dat --infile=ext_flash.flash --outfile=ext_flash.dat --width=8|16|32|64|128 --base=0x0 --end=0xFFF --pad=1 --create-lines=1 

 

Which address will the base address and the end address should set? 

Design is using standard. 

 

Regars, 

suyo
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.