- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have done a project that the LE was occpupied 97%. After we download this .sof to fpga,we found that the EPM's reset pin was compelled to low voltage temporarily. So, the fpga was booted again by epm.
but, when we download a smaller .sof file to fpga, all is OK! the pin: reset of EPM only connected to the Reset Detecting chip. I want to know why the EPM restart again. We have eliminate the reson: reconfig pin. I want to know: after config process by EPM,if the status_n pin is low voltage, the EPM can restart again? thank u!Link Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page