configuration problem in programmer

Altera_Forum · ‎08-05-2016

Hello everyone,

I actually have some problem about programming FPGA in programmer.

When I connect the FPGA in my Quartus, it detect FPGA and I don't have neither compilation problems

I have also done hardware setup and add file

But when I press start, the progress is failed immediately.

I've checked different voltage in my FPGA connection, like TDI= 3.3V TMS=3.3V TDo= 3.3V TCK=0V it seems it's correct, but when I download the program in

FPGA, it seems these voltage don't react (I think TCK, TDI and TDO should react).

Could anyone help me. I've spend a lot of time in this problem

thanks you very much.

Altera_Forum · ‎08-05-2016

do you program sof file to the device? check nconfig signal. if nconfig remain low, fpga remains reset.

Altera_Forum · ‎08-05-2016

thank you for u reply, I've program sof file. How could I check, nconfig signal?

Altera_Forum · ‎08-05-2016

What development board are you using? Your own design or a commercial one?

What programmer are you using? An Altera USB Blaster, or something else?

The more info you can provide about your setup (when you ask the question) the better the answer(s) you will get.

Altera_Forum · ‎08-16-2016

If you cannot download even sof file, you need to check power, POR(power on reset) condition is different on device. So check relevant power. And I cannot under stand TCK is not toggling, TCK is input from JTAG. The schematic for JTAG is correct?