Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12618 Discussions

hello from two tasks in microC/OS-II

Altera_Forum
Honored Contributor II
994 Views

Hi, I am new in microC/OS-II 

I am trying to run the hello MicroC/OS-II template from nios II SBT for eclipse in my own SOPC system. 

I am using Cyclone IV E ep4ce115F29c7 FPGA. 

My system has Nios II processor, 128KB memory on chip, sys_clk_timer=10ms,jtag-uart, sysid, clk=50 MHz. 

 

When I built the project: Builted completed (all looks fine) 

When I run the project: leaving target processor paused  

 

and nothing happens and I don't get the message os Hello task1... hello task 2... 

 

Help will be greatly appreciated
0 Kudos
0 Replies
Reply