- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just installed a USB PCIE 4 Port card in my IBM MT-M8141 Desktop. Card drivers are fine but the Root Hub is not installed with an Error Code 28. Are specific or generic drivers available for this situation? They were not located on the install disc. This may not be the correct place to post this but it was as close as I could find. Thanks!!
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
USB Bus Adapter Controller is Intel 82801 265A-C.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What operating system and version? Windows 10, version 1909?
What is your processor model number?
Doc
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Windows 7 32 bit with latest SP. Intel Pentium 4 3.0Gz.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Also, you know W7 is dead, right?
Doc
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, I do know Win 7 is "past it's sell by date" but there are programs on it Win 10 will not run. Thanks for the files - I'll check them soon!! Bobby
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'll report back one way or another.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried installing the software you sent me yesterday and it said "the system did not meet the minimum requirement to install". Let me know if you have any other suggestions or if we are at the end of the road. Many thanks for all your help so far!! BOBBY
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I ran a "repair" program for the drivers and it ran successfully. After that, the drive was visible. We will see if it continues to work but presently, all is now well!! Thanks, Al, for all your help!! Bobby
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Glad you have it working.
Doc
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page