Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20641 Discussions

5M1270ZF256C5N *1pcs with solder ball contamination

doris_tu
Beginner
769 Views

For Bill of Lading Numbe :3819900755  received this week from Arrowasia,

We found quality issue #106200000106A/ 5M1270ZF256C5N *1pcs with solder ball contamination as below ,and rejected from IQC team.

Please confirm next step, should be arranged 90pcs for replacement? When? Or just debit for this 1pcs ?

doris_tu_0-1633501900213.jpeg

 

0 Kudos
5 Replies
NurAiman_M_Intel
Employee
744 Views

Hi,


Thank you for contacting Intel community.


For your information, Intel PSG perform 100% Scan prior to shipment, so it's unlikely that the device will have been shipped with a contaminate solder ball. There is a high possibility that it was damaged in transit or shipping or improper storage. We have ball scan and visual test. Plus, we have drop test proved packing. The purpose of production testing during manufacturing is to screen out bad units. Intel PSG Reliability Report had stated clearly that Intel PSG performs comprehensive testing and manufacturing controls on all its products. 

We could guarantee devices leave factory door in good condition. Once shipment leaves factory, we are no longer liable as it subjects to forwarder’s handling, distributor’s handling and customer’s handling. There is no way to tell if the damages are done before devices leave factory door. Therefore, no ERMA/RMA will be proceeded due to the solder ball contamination.

 

Please contact your distributor (Arrow Asia) in this case as you received the device from them.

 

Regards,

Aiman


0 Kudos
doris_tu
Beginner
701 Views

hi sir,

we 

We received the reply from arrow asia. This is shipped through Intel directlyand did not go through the warehouse.

Please confirm the reason for the outflow of this defective 1 pcs, and kindly take the next step for ERMA/RMA , tks!

doris_tu_0-1634172977055.png

 

0 Kudos
doris_tu
Beginner
668 Views

please help to check the below message and advise,tks

0 Kudos
NurAiman_M_Intel
Employee
634 Views

Hi,


Apologize for the delay in response. I have email you through forum to get additional information.


Regards,

Aiman


0 Kudos
NurAiman_M_Intel
Employee
569 Views

We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you


0 Kudos
Reply