Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20641 Discussions

A question about FPGA configuration

ZC0001
Beginner
629 Views

Hi,all

I now using MX25L12833FMI-10G/MX25L12835FMI-10G to replace EPCQ128 to configurate CYCLONE V FPGA. The quartus II 18.1  show the successful configuration result. But when I power up the board again, the configuration chip can't configurate FPGA sucessfully. I am confused of this question.

Looking forward your help.

BestRegard.

ZCS

0 Kudos
6 Replies
NurAiman_M_Intel
Employee
603 Views

Hi,


Thank you for contacting Intel community.


May I know what type of configuration scheme that you used?


Regards,

Aiman


0 Kudos
ZC0001
Beginner
598 Views

Hi, Aiman

Thanks for your reply.

The configuration mode i used is AS. I have tried ASx1 and ASx4 modes but all failed to configurate FPGA after power up,while download the program to MX25L12833FMI-10G/MX25L12835FMI-10G is successful.

BestRegards.

ZCS

0 Kudos
NurAiman_M_Intel
Employee
568 Views

Hi ZCS,


Due to a problem in Quartus 18.1, the AS configuration fails in Cyclone V. Please try the workaround fix in below link:


https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base/component/2018/why-the-active-serial--as--configuration-fails-in-stratix-v--arr.html


Regards,

Aiman


0 Kudos
ZC0001
Beginner
559 Views

Hi,Aiman.

Thanks for your reply.

I installed the patch for quartus, but it doesn't resolve this problem.

Can you give me some other advice. Thanks.

 

Best Regards

ZCS

0 Kudos
Reply