Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20645 Discussions

ASMI IP to update the FPGA problem

open01
New Contributor I
571 Views

Hello everyone,
I recently want to use ASMI's IP to update the content of FPGA,
And my architecture is shown in Figure 1Fig1.PNG

My question is,
After I deleted all the unused FF data after the .rpd file and wrote the EPCQ through ASMI, I could not successfully configure the FPGA after powering on again.
I have compared the data before and after writing, and they are no different.

Are there any suggestions for my approach?

Thanks for your answers.

0 Kudos
1 Solution
NurAiman_M_Intel
Employee
559 Views

Hi,


Thank you for contacting Intel community.


Kindly refer to the ASMI user guide below and let us know your concern:

ASMI I: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_altasmi_parallel.pdf


ASMI II: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-asmi2.pdf


Regards,

Aiman


View solution in original post

0 Kudos
2 Replies
NurAiman_M_Intel
Employee
560 Views

Hi,


Thank you for contacting Intel community.


Kindly refer to the ASMI user guide below and let us know your concern:

ASMI I: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_altasmi_parallel.pdf


ASMI II: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-asmi2.pdf


Regards,

Aiman


0 Kudos
open01
New Contributor I
550 Views

Hi, thanks for your reply

I have solved my problem.

It’s my own problem, I thought the end message of .rpd was 2b c0(Fig)
But later it was discovered that there were other messages besides FF.

open01_0-1610437306424.png

 

0 Kudos
Reply