Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

About LTM SOPC Component Generation

Altera_Forum
Honored Contributor II
‎01-05-2014 11:47 PM
1,023 Views

Hello, 

 

I have created a SOPC component for the Terasic's LTM. The component is attached to the Avalon bus through a conduit interface for SRAM and LTM and MM slave interface for the Nios2. All is fine until now. But I need two additional signals: LTM_NCLK and LTM_DEN. These, I need to connect to the LTM. But I don't know how to drive the signals from an SOPC component to the top level. Does anyone have an idea? 

 

Regards, 

Berk
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-06-2014 11:05 PM
321 Views

Ok. I tried to route them also as conduits since they go outside as well and it worked.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.