Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21339 Discussions

Beginner Question For Quartus II - Splitting a Bus into Seperate Bits

Altera_Forum
Honored Contributor II
‎12-17-2012 08:58 PM
1,569 Views

Hi, I'm new to using Quartus and I have a simple question. I'm using a 3 bit counter and trying to put the output into a 3 input NAND gate as shown in the image below. The output on the counter only has one connector. How could I properly split this up? Thanks in advance. 

 

https://www.alteraforum.com/forum/attachment.php?attachmentid=6578
quartuspic.jpg
(Virus scan in progress ...)
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎12-17-2012 10:23 PM
666 Views

The output actually has three connections. Click on it and extend it, then connect the three NAND inputs to it.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.