- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using an Avalon MM master BFM and connecting it to DDR4. I am able to perform single write and single read operation successfully. When I try to do the burst operation, I am unable to see burst of data being transferred. The burst size and burst count signals of Avaon BFM are being varied for this but I don't see any change in transfer type. Is there any specific configuration to be done for controlling burst mode transfer? Also for each data,which is part of the burst transfer should I give address individually or will my BFM perform the address increment operation automatically(enabled the begin burst transfer checkbox so expecting it to perform on its own)? Thank You.Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page