Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20638 Discussions

Can I use EPCQ32A with ASx4 configuratiton mode at Cyclone10LP(10CL120)?

KMats45
Beginner
358 Views

I'd like to carry out a configuration of cyclone10lp by ASx4 mode of EPCQ32A. But I cannot find circuit example on datasheet and Web resources.

 

I thought I connect DATA0-3 of EPCQ to DATA0-3 of FPGA simply at first. But Cyclone10LP's ASDO is assigned at DATA1. Does DATA0 of EPCQ (ASDI) connect to DATA1 of FPGA (ASDO) to say so? If I meet, DATA0 of EPCQ has to connect DATA1 of FPGA and DATA1 of EPCQ to DATA0 of FPGA. I can't understand.

 

1.I'd like to know whether this circuit composition is possible.

2.Please tell me circuit example. (or connection method of each pins of EPCQ-FPGA)

3. And I'd like to know how to connect a 10-pin download cable.

 

Please tell me immediately.

0 Kudos
2 Replies
Busy
Novice
246 Views

>>Please tell me immediately.

I'm not sure this is the best way to have an answer...

 

Cyclone 10 LP only accepts ASx1 configuration mode (DATA[2..7] are used for FPP mode, not for AS).

Example of AS can be found in 'Intel® Cyclone® 10 LP Core Fabric and General Purpose I/Os Handbook' (chapter 6.1.1)

You can use 'Intel® Cyclone® 10 LP Device Family PinConnection Guidelines' so as to have pins guideline.

0 Kudos
KMats45
Beginner
246 Views

Thank you so much.

I have decided to adopt a ASx1 configuration.

I'm thankful for your early answer.

0 Kudos
Reply