Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20641 Discussions

Crystal Clock at EPF10K100EQC240-3

Altera_Forum
Honored Contributor II
861 Views

Hey, 

 

I am using EPF10K100EQC240-3 IC with 8MHz crystal (SG-615P). 

When I measure signal on the crystal I see only 60Hz (in my country the frequency of AC power is 50Hz) instead of 8MHz. The board is working well. 

 

Can some explain me please how is it possible? 

 

Thanks ahead 

 

 

 

0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
203 Views

How did you measure your clock signal? Did you use a scope? What does the waveform look like? Are you sure you have a good ground connection?

0 Kudos
Altera_Forum
Honored Contributor II
203 Views

I already understood where was my mistake. 

I used digital scope and the sampling frequency was too low.
0 Kudos
Reply