- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
We have a custom made PCB with a Cyclone 10 GX FPGA that uses ASx4 configuration scheme. Everything works fine except the boot (FPGA entering User Mode) time. It's too long to pass our requirements. It takes around:
1- Fast POR: 220 ms
2- Standard POR: 360 ms
We would like to get it under 100 ms even if it gets to changing design and configuration scheme.
Kindly advise on whether this is possible or not, and how.
Thanks,
-Sulaiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may refer to cyclone 10 gx for the estimated configuration time for every configuration scheme.
You might need to consider PS configuration scheme if you are looking for time with less than 100 ms.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may refer to cyclone 10 gx for the estimated configuration time for every configuration scheme.
You might need to consider PS configuration scheme if you are looking for time with less than 100 ms.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could this be done without using another FPGA or CPLD?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For PS configuration, you need a CPLD or a processor for that.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page