Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21569 Discussions

Cyclone 4 input voltage tolerance

Altera_Forum
Honored Contributor II
‎05-03-2011 11:49 AM
2,269 Views

Hi. I am using an Altera Cyclone® IV EP4CE22F17C6N FPGA on a Terasic DEO NANO board. I was wondering if this device is 5V tolerant on its inputs, specifically to the FPGA. I have not seen anything in either Terasics or Alteras documentation to suggest whether it is or isn't. As I haven't seen anything saying it is, I'm going to presume it is not 5V tolerant for the time being. But if someone could clear this up for me, I would appreciate it. 

 

Regards, Glen.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-03-2011 05:56 PM
1,338 Views

 

--- Quote Start ---  

I have not seen anything in either Terasics or Alteras documentation to suggest whether it is or isn't. 

--- Quote End ---  

Cyclone IV handbook has clear words about it. No recent Altera FPGA is 5V tolerant.
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.