Cyclone IV GX configuration voltage problem

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Cyclone IV GX configuration voltage problem

1,047 Views

im using Cyclone IV GX 150.

According to your documents 'Cyclone IV Device Handbook' Page 175:

http://www.alteraforum.com/forum/attachment.php?attachmentid=12902&stc=1

The High logic of the nSTATUS, CONF_DONE, nCONFIG, MSEL[] should be the VCCIO of bank3.

Meanwhile, according to your documents '150-0311003-B1 6XX-43286R'; it is your model design 'cyclone iv gx fpga development kit board'. In your design schematic file, the bank3 has a 1.8V support voltage, but the nSTATUS, CONF_DONE, nCONFIG, MSEL[] configuration pin in bank3 are linked to a 2.5V high logic.

So, it that ok for us to have a 1.8V Bank3 support while link the nSTATUS, CONF_DONE, nCONFIG, MSEL[] to 2.5V high voltage?

217 KB

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.