Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20641 Discussions

Cyclone IV and Arria V combo

Altera_Forum
Honored Contributor II
1,150 Views

Hello, 

 

I would like to ask if there is some special stesp to take when connecting de0-nano board to Arria V GX Starter Kit. I must set 3.3 V I/O Standard in Pin Planner. Anything else? My application is simple: SPI master as de0-nano board and SPI slave on Arria V GX board. 

 

Thank you!
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
179 Views

I think you've about covered it. Perhaps more generically, ensure the signals are connected between banks powered from at same voltage on both boards, not necessarily 3.3V, although 3.3V will do fine. 

 

Make sure you also take a ground connection between the boards. 

 

Regards, 

Alex
0 Kudos
Reply