Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
19188 Discussions

DE2 board SMA connector

hucklord
Beginner
124 Views

I have an older (now phased out) DE2 board, and I'd like to use it to clock a PCB at 50 MHz. Can I use the SMA connector as an output? It is designated as the "External clock input".

 

If I can't use it as an output, what is the best alternative? I don't think a regular GPIO pin should carry a 50 MHz signal.

0 Kudos
2 Replies
AR_A_Intel
Employee
103 Views

Hello

 

Welcome to INTEL forum. For clock setting on the DE2 board it would be better if you could contact Terasic for enquiry related to Terasic board. https://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=12&No=20    

Please accept my apologies for not being able to assist you fully as this is out of my expertise


AR_A_Intel
Employee
88 Views

We have not heard from you and I hope that my last note clears up this matter. If you don’t have any further question, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Reply