Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
18972 Discussions

Does A10 GX input differential Termination Resistor(RD) OCT support Calibration?

xytech
New Contributor I
555 Views

Answer:

1.Rd OCT does not support calibration

2.Only one RZQ pin is needed for one IO column banks if they have same VCCIO

3.Internal 100ohm diff input termination on ref clock pins of GXB do not support calib, neither.

 

Finally I still can not understand why Intel and it's representative is so irresponsive on technnical support. Disappointing.

0 Kudos
10 Replies
xytech
New Contributor I
120 Views

UP

xytech
New Contributor I
120 Views

..

xytech
New Contributor I
120 Views

up

xytech
New Contributor I
120 Views

up

xytech
New Contributor I
120 Views

Answer for Q3. refer from OCT USER GUIDE

OCT.png

xytech
New Contributor I
120 Views

Possible Reference for Question 2. Rd does not support OCT Calibration

 

https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base...

Device Family: Stratix® II

Type: Answers

Area: Component

Last Modified: September 11, 2012

Does the differential on-chip termination (OCT) require calibration resistors?

Description

Differential OCT does not require calibration resistors. Calibration resistors are only required for series and parallel OCT.

 

xytech
New Contributor I
120 Views

fkoff

xytech
New Contributor I
120 Views

........

xytech
New Contributor I
120 Views

up

SreekumarR_G_Intel
120 Views

Hello ,

Sorry , Apologize for delay in response ,

for reason i didnt get the notification for the post.

 

Thank you ,

 

Regards,

Sree

Reply