Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

EPCS selection for Cyclone 10 FPGA

NShan12
New Contributor I
‎10-31-2019 03:39 PM
1,032 Views

I have a design that amounts to roughly 8000 Logic elements and need help in choosing an appropriate EPCS device so that it turns out cheapest and less area consuming on board.

The size of which file defines the capacity of EPCS to be selected?

 

Thank you in advance!

0 Kudos

Link Copied

2 Replies
ShafiqY_Intel
Employee
‎11-05-2019 07:53 AM
850 Views

Hi NShan12,

 

Usually we determine the size of the configuration device based on Uncompressed Configuration Bit Stream Size of our design.

 

You can refer to Cyclone 10 datasheet for this details (page 53, table 54):

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10gx-51002.pdf#page=53

 

Thanks

0 Kudos
Copy link
NShan12
New Contributor I
‎11-06-2019 02:52 PM
850 Views
In response to ShafiqY_Intel

Thank you @ShafiqY_Intel​ 

In response to ShafiqY_Intel
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.