- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Quartus version 18.0 on linux.
FPGA MAX10 device number 10M08SAM156CBG
I programmed the same image yesterday. It was fine.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the error message?
#iwork4intel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CONF_DONE pin failed to go high in device 3.
I have secure_jtag enabled.
I could load the image yesterday. I had pin to bring out FSM of the secure-jtag block that I got from Intel.
so I change the image to look at different internal signals.
Today, I can't erase, can't load .sof or .pof.
Please help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nhu,
Sorry i don't really understand the whole scenario. Could you please elaborate further like what you have done and etc?
You mentioned about "pin to bring out FSM of the secure-jtag block that i got from Intel", may i know what does that mean?
Thank You.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page