Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
18466 Discussions

Gigabit Ethernet using FPGA in cyclone 5 De10 nano board

Manav
Beginner
141 Views

I am using the cyclone 5 DE10 nano board. Is there any way I can connect the ethernet PHY to the FPGA using the TSE IP? Can the pins be shared between the HPS and the FPGA?

0 Kudos
1 Reply
Deshi_Intel
Moderator
133 Views

Hi,


FYI... Intel FPGA forum community is meant to support dev kit board developed by Intel only and not for 3rd party vendor board like this DE10-Nano board which is development by Terasic


  1. Is there any way I can connect the ethernet PHY to the FPGA using the TSE IP ?
  • I can comment TSE IP do support RGMII interface but I am not familiar with the PHY chip on DE10-nano board.
    • Feel free to contact terasic directly to check out with them
  1. Can the pins be shared between the HPS and the FPGA ?
  • No, Cyclone V SOC HPS has its own dedicated IO pins while FPGA has its own dedicated IO pins


Thanks.


Regards,

dlim


Reply